Wrench you can store on board that you don’t need a ratchet for. It also floats. Should fit 150-350 2006-present motors. This is 3D printed out of ASA filament which is similar to ABS in properties, but ASA is stronger and has better UV resistance.
Snug fit. 1. Disconnect wire going to the bottom of the filter 2. Slide wrench up the filter and ensure it sits flush against the housing 3. Using wrench and hand loosen filter and replace 4. Spin filter housing back on with new filter and use wrench to tighten filter snug tight. Don’t over tighten.
